My mountain bike stem is too short for the standard Garmin Edge 200 mount but I don't want a gps on my handlebars to graze a branch, rock, or whatever a fall might bring. Solution? Flip this SRAM thingy backwards so the computer is just above the stem bolt but below the bar height, protection and a perfect line of vision. If my stem was a little longer, this extra expense wouldn't have been necessary but it looks pretty stealth mounted backwards. Go figure.
Despite tightening this quite well on it came use with 5 mins of starting my first run with the mount. Eventually lost the hex bolt that secures this on that ride. Love the elevated position in front of the handle bars. Had to replace the missing bolt with another screw and nut that works ok.
I use this for my Edge 510. The mount was easy to install, the 510 clicks into it solidly and it's also easy to change the angle for better viewing. A great value.
The mount is used on a vintage (1974) Raleigh road bike. I had to wrap rubber around the handlebar to fit the mount. It works fine.
This SRAM Quickview Mount securely holds your Garmin where you can see it at a reasonable price. My only concern when ordering the SRAM Quickview was durability. With the Garmin computer being twisted in and out of the mount I was concerned that the interface would become worn and less secure. After one year of use the mount shows no signs of wear at the interface. The mount is on my road bike and I ride it at least 3 times a week. Also, very easy to install.
Cheap, Solid, Light and it just works Great! I bought four of them for way less than the cost of one of the Chi-Chi ones, Never had an issue with it not securely holding my Garmin.
Installed on a gravel bike over rough terrain, and it works fine!
The New Garmin 1030 is a little long for this SRAM mount in some inclinations. Decreasing the angle solves the problem but doesn't enhance the viewing.
This mount does exactly what it should for a lot less than a Garmin mount. Only complaint would be you need a star wrench for installation rather than a normal allen wrench. Fortunately I had one, but not on my tool.
It gets the Garmin out front and center so that glancing down and getting a bit of info is just as easy at it sounds as I type this. Also, it takes such little real estate on the bar that it doesn't feel crowded when I have a light (or two) up there and I want to place my hands on the tops when climbing. Great product at a good price.
And won't break the bank
I've bought these for all my bikes using the Garmin 520. The short one for the Mtn bike works great. The value for these compared to the more expensive one's can't be beat.
Much cheaper alternative for the Garmin part. Fits perfectly.
It can be installed facing forward or backward for the rear rider on a tandem.
I have had no problems with this at all. It works as advertised. Hated paying as much as I did for it, but no way I was paying what the other products were asking.
Cheaper price than other brands. Serves the purpose.
Holds my Garmin 200 nice and tight.......
Purchased for all my bikes- and sons-that should say it all!
This is a handy little mount to get my Garmin in a good spot so you can take a peak at your Garmin.
If you have been shopping for a quick mount for a Garmin you cannot beat this deal!
