I have old Schwinn vintage bikes that have very limited tire selection. The tires do not have the new puncture resistance rubber so these liners are great so any glass will not give you a flat. I use these liners on all my bikes and ride about a 100 miles a week. Each time I have to dodge a broken glass field and other bikers just go pop and whistle as their tires go flat I have only had one flat with these liners from a large piece of glass after about 6000 miles. These liners will last for 3 or 4 tires so it is a small cost to prevent flats
I use these on all of my bikes....from grocery getter to mtb.....to ease my mind ,worrying about the dreaded flat.
Easy to fit and install....no having to cut to length cause they come in numerous sizes to choose from. Flexable yet strong along contact patch,no sharp edges to sand down or cut. Great product.
Put this product in my gravel bike tires to keep the tiny needle shards of disintegrated truck tire steel cords on the highway (normal in Arizona heat) and the goat head thorns that are off road. So far, I haven't had a puncture since putting them in. Worth the price and the frustration in dealing with both. Easy to install, and not a problem if and when the rare flat does a occur. A fair price for an excellent product.
I use these on my road bike and I haven't had a flat yet. I was having a lot of problems with those little wires from blown racial truck tires. I use gator tires with these inside, by the way they were easy to install. I check the tires to get the wires out as often as I can and this works well for me. Remember if you don't get the wires out occasionally they will work their way thru to the tube.
I am a long distance cyclist. Installed Mr. Tuffy and have ridden three 500 milers and not one flat. This is a great value. You must be a bit careful on installing the liners to make sure they are seated properly but this is not a big deal. I have this product on all my bikes and no flats!!
I have worn tires down to the threads before with these in them and not had flats, nor did I even notice how thin the tires were since I usually start noticing the tires are getting worn when I start getting flats. Cuts out flats from punctures even when the tires are getting pretty worn and you usually start getting flats.
You still have to keep your tires pumped up regularly though since they do not stop pinch flats, as well as use the standard caution while installing tires to be sure you don't pinch the tube upon installing the tiretube (i.e. punctures are not the only source of flats, which some people may not know...)
If you ride in goathead country, and are tired of dealing with the mess of sealants like Slime, then, hello. I have been through countless goathead experiences. I have even taken tubes, cut off the valve stem, slit the tube on the innerside and used it as a shield between the tire carcass and the functioning tube filled with Slime, which makes your bike weigh a ton. No more folks! These babies are cleaner and lighter, and really work! Thank you Mr. Tuffy!
Upon installation, just place the still rolled-up Mr. Tuffy inside the tire carcass, and unroll it inside the tire, then insert the partially inflated tube to hold it in place.
Usually get six to eight flats a year. Decided to give the Tuffy's a try. So far no flats, have about 550 miles on them so far. I use them on my training bike where I am not concerned about weight. They are easy to install and have had no flats.
After several years riding with these liners, I can remember only 1 flat. The only time I take tires off anymore is to put on new ones. I easily go up to 4,000 miles without a flat. Also, if someone wasn't told they were in there and rode the bike they would never be able to tell the difference.
I ride my Catrike recumbent 15-20 miles/day. The recurring flats picked up from riding on the local farm roads were happening several times a week. I remembered using the Mr. Tuffy liners on a mountain bike quite a few years ago. I installed them on the two 20 front wheels and no more flats! I bought a liner for my 26 rear wheel but haven't installed it yet because flats haven't been an issue with the rear yet. (Different tube/tire on the rear..) I won't hesitate to put it on at the first sign of trouble. I no longer head out to the garage for my morning ride to find my trike listing with a flat. Don't the let the weight of these liners scare you away.
Installing liners took about 30 minutes, partially inflated tube helps to keep the liner centered on tire tread. No more stress about seeing and avoiding road puncture hazards on those dark rainy nights. Have been riding with tire liners since 1982 on both Mountain and Road bikes now have them on my Hybrid, Over 30 years without a flat due to a puncture! Here's a tip if you get sidewall damage due to a pinch or sharp object slit you can deflate and shift liner to the side of the tire between the tube and the damage inflate and RIDE back!